What does a non-isolated power supply look like?(2)

Due to the wide variety of integrated circuits used in communication equipment, their power supply voltages are also different. In the communication power supply system, a high-frequency DC-DC isolation module power supply with high power density is used, which is converted from the intermediate bus voltage (usually 48V DC) to Various DC voltages are required, which can greatly reduce losses, facilitate maintenance, and are very convenient to install and increase. Generally, it can be directly installed on the standard control board, and the requirement for the secondary power supply is high power density. Due to the continuous increase of communication capacity, the capacity of communication power supply will also continue to increase.

non-isolated Marine boost power supply The distinction between good circuit principles and bad circuit principles can often only be made from a professional perspective. At this stage, power modules can be roughly divided into two types: bare board and potting. The bare board can be based on intuitive methods, such as the layout of electronic components is reasonable, neat, generous, neat, and the solder joints are bright and straight. For encapsulated modules, it is not possible to see the internal conditions, but since the internal conditions are not exposed, it is much better in terms of safety and performance metrics. The soldering process can include hand soldering and wave soldering. The quality of the wave soldering process of mechanized production is better than that of manual soldering.

non-isolated Marine boost power supply Two: chip components

The core of the Marine boost power supply is the IC, just like the brain of the Marine boost power supply, the quality of the IC directly affects various parameters of the Marine boost power supply.