What kind of Marine boost power supply will be higher(2)

The quality of the resolution of the circuit schematic is usually done from a professional perspective. This power module can be divided into two kinds of bare board and packaged, according to an intuitive way of bare board, such as electronic components layout is reasonable and orderly, generous, orderly, and the net pad is lit upright. Also, stationary modules will not be able to see what's going on inside, but it's much better not to be exposed due to safety and performance levels. The soldering process can include both wave soldering and manual soldering, and the quality of the mechanized production process of wave soldering is superior to that of manual soldering.

Two: the components of the chip

For the ADJ output pin, it is divided into input side adjustment and output side adjustment. The output side is adjusted in the same way as the TRIM pin. The input side adjustment can only increase the output voltage. At this time, one end of the potentiometer is connected to the center, and the other end is connected to the ground of the input end.

The core problem of the  Marine boost power supply is the IC, which is like the brain of the  Marine boost power supply. The quality of the IC can directly affect the various working parameters of the  Marine boost power supply.