Jamaica acdc power module potting requirements(1)

The potting of the acdc power module is very important. This process not only involves the protection of the power module potting acdc power module (waterproof, moisture-proof, dust-proof, anti-corrosion, etc.), but also involves the protection of the power module. thermal design.

Commonly used power module potting materials are divided into three categories: epoxy resin, polyurethane and silicone rubber

power source is realized through the power transfer switch.
Modern UPS generally adopts pulse width modulation technology and modern power electronic devices such as power MOSFET, IGBT, etc., the noise of power supply can be reduced, and the efficiency and reliability can be improved. The introduction of microprocessor software and hardware technology can realize intelligent management of UPS, remote maintenance and remote diagnosis.
The maximum capacity of the online UPS can be made to 600kVA. The development of ultra-small UPS is also very rapid, and there are already 0.5kVA, lVA, 2kVA, 3kVA and other products of various specifications.

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad Marine boost/buck voltage power supply manufacturers also use this epoxy resin acdc Marine boost/buck voltage power supply module. However, due to stress problems, the failure rate of this Marine boost/buck voltage power supply is very high, and buyers are miserable.