Welcome to Nanjing Pengtu Power Supply Co. Ltd.

What is the role of the quotation?(2)


module power supply

For the TRIM output pin, the center of the output potentiometer and the center TRIM are all connected to +S, -S in the pin module, and the other two ends are connected to +S, -S respectively. There is no +S, and the -S ends receive the positive and negative outputs of the corresponding main circuit respectively (+S is connected to +Vin, -S is connected to -Vin), and then adjust the potentiometer. The resistance of the potentiometer is generally 5~10kΩ.

(3) Before the installation is completed and the power is turned on, the wiring on each terminal should be checked and checked again to ensure that the input and output, AC and DC, single-phase and multi-phase, positive and negative, voltage and current values are correct. Prevent the occurrence of reverse and wrong connections.
(4) For high-power power supplies, there are generally two or more "+" output terminals and "-" output terminals. In fact, they belong to the same output electrode, but for the convenience of user wiring, they are connected together internally.
(5) The module power supply is not allowed to work at full load for a long time. The utilization rate of linear power supply should be controlled within 60%; the utilization rate of switching power supply should be controlled within 80%, otherwise it may cause early artificial failure of module power supply.

quotation The ADJ output pins are divided into input adjustment and output adjustment. Output trim and output trim. The adjustment method of the TRIM pin is the same. When one end of the potentiometer is connected to the center, the output voltage can only increase the output voltage, and the other end is connected to the ground of the input.

Input protection circuit General customized non-standard Marine boost voltage power supply customized module (factory supply products use built-in filters, which can meet the requirements of general Marine boost voltage power supply applications. If a more demanding power system is required, quotation the input filter network should be added. Either LC or π can be used but care should be taken to choose a smaller inductance and larger capacitance.