Trinidad and Tobago acdc power module potting requirements(2)

rectangular wave of 20 kHz.
Due to the poor working conditions of the welding machine power supply and frequent short-circuit, arcing and open-circuit changes, the working reliability of the high-frequency inverter rectifier welding machine power supply has become the most critical issue and the most concerned issue by users. . The microprocessor is used as the relevant controller of pulse width modulation (PWM), and through the extraction and analysis of multi-parameter and multi-information, the purpose of predicting various working states of the system is achieved, and then the system is adjusted and processed in advance to solve the problem. The reliability of high-power IGBT inverter power supply is improved.
Foreign inverter welding machines can achieve a rated welding current of 300A, a load duration rate of 60%, a full-load voltage of 60~75V, a current adjustment range of 5~300A, and a weight of 29kg.

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad Marine boost/buck voltage power supply manufacturers also use this epoxy resin acdc Marine boost/buck voltage power supply module. However, due to stress problems, the failure rate of this Marine boost/buck voltage power supply is very high, and buyers are miserable.

At present, the most commonly used power module is the addition of silicone. This kind of silica gel is generally 1:1, which is easy to operate. When acdc potting power modules, attention should be paid to its thermal conductivity. However, the bonding ability is not very strong, and it can be improved with primer.

Polyurethane has been used in China for a period of time, but due to its high hardness, inconvenient maintenance, and the price reduction of silicone rubber, the cost performance of polyurethane is not high.