Ireland acdc power module potting requirements(2)

The high-voltage DC power supply for electrostatic precipitator has been developed in China. The commercial power is rectified into DC, and the full-bridge zero-current switch series resonant inverter circuit is used to invert the DC voltage to a high-frequency voltage, which is then boosted by a high-frequency transformer, and finally rectified. for DC high voltage. Under the condition of resistive load, the output DC voltage reaches 55kV, the current reaches 15mA, and the operating frequency is 25.6kHz.

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad Marine boost voltage power supply manufacturers also use this epoxy resin acdc Marine boost voltage power supply module. However, due to stress problems, the failure rate of this Marine boost voltage power supply is very high, and buyers are miserable.

At present, the most commonly used power module is the addition of silicone. This kind of silica gel is generally 1:1, which is easy to operate. When acdc potting power modules, attention should be paid to its thermal conductivity. However, the bonding ability is not very strong, and it can be improved with primer.

Polyurethane has been used in China for a period of time, but due to its high hardness, inconvenient maintenance, and the price reduction of silicone rubber, the cost performance of polyurethane is not high.