What is the role of the manufacturer?(1)

For customized non-standard power supply customized module (factory products with TRIM or ADJ (adjustable) output pins, the output voltage can be adjusted within a certain range through resistors or potentiometers, manufacturer and the general adjustment range is ±10%.

For the TRIM output pin, the center of the output potentiometer and the center TRIM are all connected to +S, -S in the pin module, and the other two ends are connected to +S, -S respectively. There is no +S, and the -S ends receive the positive and negative outputs of the corresponding main circuit respectively (+S is connected to +Vin, -S is connected to -Vin), and then adjust the potentiometer. The resistance of the potentiometer is generally 5~10kΩ.

high frequency switch
The rapid development of the communication industry has greatly promoted the development of communication power. High frequency miniaturized switching power supply and its technology have become the mainstream of modern communication power supply system. In the field of communication, the rectifier is usually called the primary power supply, and the direct current-direct current (DC/DC) converter is called the secondary power supply. The role of the primary power supply is to convert the single-phase or three-phase AC power grid into a DC power supply with a nominal value of 48V. In the primary power supply for program-controlled switches, the traditional phase-controlled regulated power supply has been replaced by a high-frequency switching power supply. Controlled in the 50-100kHz range for high efficiency and miniaturization. In recent years, the power capacity of switching rectifiers has been continuously expanded, and the single-unit capacity has been expanded from 48V/12.5A, 48V/20A to 48V/200A, 48V/400A.

manufacturer The ADJ output pins are divided into input adjustment and output adjustment. Output trim and output trim. The adjustment method of the TRIM pin is the same. When one end of the potentiometer is connected to the center, the output voltage can only increase the output voltage, and the other end is connected to the ground of the input.