What is the role of the customized non-standard power supply customized module (factory?(1)

(6) For the module power supply, some manufacturers have a fixed resistance directly connected to the adjustable terminal (ADJ) from the factory. When using, the user must configure a potentiometer with the corresponding resistance value to replace the fixed resistance. However, it should be noted that when the adjustable terminals are in an open state, loading is never allowed.
(7) In order to achieve sufficient heat dissipation, the module power supply should be installed in a location with better air convection. Generally, when the working current of the linear power supply is above 4A, or the working current of the switching power supply is above 7A, forced air cooling should be installed. In addition, no other items are allowed on the module power supply housing.
(8) The module power supply is generally suitable for resistive-based loads. If it needs to be applied to capacitive-based or inductive-based loads, it should be explained in the order contract in advance and customized by the manufacturer.

For quotation products with TRIM or ADJ (adjustable) output pins, the output voltage can be adjusted within a certain range through resistors or potentiometers, customized non-standard power supply customized module (factory and the general adjustment range is ±10%.

For the TRIM output pin, the center of the output potentiometer and the center TRIM are all connected to +S, -S in the pin module, and the other two ends are connected to +S, -S respectively. There is no +S, and the -S ends receive the positive and negative outputs of the corresponding main circuit respectively (+S is connected to +Vin, -S is connected to -Vin), and then adjust the potentiometer. The resistance of the potentiometer is generally 5~10kΩ.

customized non-standard power supply customized module (factory The ADJ output pins are divided into input adjustment and output adjustment. Output trim and output trim. The adjustment method of the TRIM pin is the same. When one end of the potentiometer is connected to the center, the output voltage can only increase the output voltage, and the other end is connected to the ground of the input.