What is the role of the custom-make?(1)

For non-standard customization products with TRIM or ADJ (adjustable) output pins, the output voltage can be adjusted within a certain range through resistors or potentiometers, custom-make and the general adjustment range is ±10%.

For the TRIM output pin, the center of the output potentiometer and the center TRIM are all connected to +S, -S in the pin module, and the other two ends are connected to +S, -S respectively. There is no +S, and the -S ends receive the positive and negative outputs of the corresponding main circuit respectively (+S is connected to +Vin, -S is connected to -Vin), and then adjust the potentiometer. The resistance of the potentiometer is generally 5~10kΩ.

The high-voltage DC power supply for electrostatic precipitator has been developed in China. The commercial power is rectified into DC, and the full-bridge zero-current switch series resonant inverter circuit is used to invert the DC voltage to a high-frequency voltage, which is then boosted by a high-frequency transformer, and finally rectified. for DC high voltage. Under the condition of resistive load, the output DC voltage reaches 55kV, the current reaches 15mA, and the operating frequency is 25.6kHz.

custom-make The ADJ output pins are divided into input adjustment and output adjustment. Output trim and output trim. The adjustment method of the TRIM pin is the same. When one end of the potentiometer is connected to the center, the output voltage can only increase the output voltage, and the other end is connected to the ground of the input.