Bhutan acdc power module potting requirements(1)

The potting of the acdc power module is very important. This process not only involves the protection of the power module potting acdc power module (waterproof, moisture-proof, dust-proof, anti-corrosion, etc.), but also involves the protection of the power module. thermal design.

Commonly used power module potting materials are divided into three categories: epoxy resin, polyurethane and silicone rubber

input protection circuit
General module power products have built-in filters, which can meet the requirements of general power supply applications. If a more demanding power system is required, an input filter network should be added. An LC or π-type network can be used, but care should be taken to choose a smaller inductance and larger capacitance as much as possible.
In order to prevent the transient high voltage of the input power supply from damaging the power supply of the module, it is recommended that the user connect a transient absorption diode at the input end and use it with a fuse to ensure that the module is within a safe input voltage range. In order to reduce common-mode noise, Y (Cy) capacitors can be added, and a few nf high-frequency capacitors are generally selected. R is a fuse, D1 is a protection diode, and D2 is a transient absorption diode (P6KE series).

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad 24V input power supply manufacturers also use this epoxy resin acdc 24V input power supply module. However, due to stress problems, the failure rate of this 24V input power supply is very high, and buyers are miserable.